142

Do you wait on Steam depot or ACE before you load?

Safety

Arena Breakout Infinite cheats Discord keeps promising the same build across patches. Last week ACE flipped, the overlay attached, then inventory list went blank mid-raid on Armory.

How do you treat detection in practice: conservative FOV, no snaplines on stream, wait for #status, or all of the above?

5 replies

Replies 5

From the thread
u/banner_only·5 hours ago

All of the above. Status banner first, then a zero-value raid, then ranked kits. Never the other order.

u/no_snapline·4 hours ago

If you record, turn snaplines and draw FOV off. Those are the frames that look obvious in a clip even when boxes look fine.

S
u/status_first·3 hours ago

I stream to a private Discord. I will hide FOV circle and target line.

u/armory_rat·2 hours ago

Inventory blanking after ACE is usually a pawn read delay. Reload the config from the portal, do not mash Enable on visuals.

u/wait_out·55 min. ago

If #status says updating, sit it out. A 200k kit is not worth proving a half-patched ESP.