Arena Breakout Infinite Cheat Config Guide: Creating, Saving, Loading and Managing Configurations

This cheat config guide is the profile system: create, save, load, delete. One FOV and one ESP range cannot cover Normal Farm and Forbidden Armory. Configs exist so those raids do not share a slider set.

After an ACE or Infinite patch, a known-good profile is faster than rebuilding smoothness from memory.

Create config

Create starts a named profile. Name it by map and raid type: `valley-lockdown`, `armory-normal`, `northridge-forbidden`. Do not name it after a YouTuber. You will not remember what FOV they used.

Start from a conservative base: small aimbot FOV, readable ESP distance, combat mode on, corpse min-price high.

Save config

Save writes the current sliders to that name. Save after you finish a raid that felt right, not after a chaotic wipe. If the raid was bad, you will save panic FOV.

Save a copy before you experiment. ACE patches sometimes reset overlay defaults. A dated copy is the rollback.

Load config

Load applies a saved profile before you ready up. Load in the lobby, not mid-raid, unless the loader says hot-load is safe on the current build.

Match HUD density from the interface guide inside each profile so font size does not surprise you on a 1440p swap.

Delete config

Delete removes junk names. Old Season 6 FOV presets will fight Season 7 recoil and new rifles. Clear them so you cannot load a dead profile on accident.

Keep at least one “patch test” profile with everything conservative. That is the file you load when status just flipped back to online.

Why this is a buying column

Suites without create/save/load/delete force one slider set. That fails the config column in the ABI cheats review.

Profiles are how a maintained PC suite stays usable across maps. Arena Breakout cheats is the product hub for that suite, including cloud-saved configs when the portal offers them.

FAQ

How many configs do I need?

Three is enough for most players: Normal, Lockdown, Forbidden. Add a fourth if Armory and Valley never agree on ESP range.

Should I share configs?

Only inside your own accounts. Other people’s smoothness assumes their DPI and monitor. Import, then retune FOV.

What if load does nothing after a patch?

The build likely reset keys. Check status, update the loader, create a new profile from the conservative base, then copy sliders by hand if import is blocked.

Do configs include HWID?

No. Identifier tools are a separate product. See the HWID explainer.

Can I delete the active profile?

Load another profile first. Deleting the active one can drop you to defaults mid-setup.